PCI-EXPRESS 1: Disabled PCI-EXPRESS 2 on bus 00 - 00 In: serial Out: serial Err: serial Net: eTSEC2: No support for PHY id ffffffff; assuming generic eTSEC3: No support for PHY id ffffffff; assuming generic eTSEC4: No support for PHY id ffffffff; assuming generic eTSEC1, eTSEC2, eTSEC3, eTSEC4 Hit any key to stop autoboot: 0 => run nfsboot Speed: 100, full duplex Using eTSEC1 device TFTP from server 192.168.0.2; our IP address is 192.168.0.50 Filename 'uImage'. Load address: 0x1000000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ####################################### done Bytes transferred = 3860224 (3ae700 hex) Speed: 100, full duplex Using eTSEC1 device TFTP from server 192.168.0.2; our IP address is 192.168.0.50 Filename 'sbc8641d.dtb'. Load address: 0x400000 Loading: ### done Bytes transferred = 12288 (3000 hex) ## Booting kernel from Legacy Image at 01000000 ... Image Name: Linux-2.6.37 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 3860160 Bytes = 3.7 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 00400000 Booting using the fdt blob at 0x400000 Uncompressing Kernel Image ... NIP: 00012AAC XER: 00000000 LR: 000002C4 REGS: 1fea3778 TRAP: 0700 DAR: 0 MSR: 00081002 EE: 0 PR: 0 FP: 0 ME: 1 IR/DR: 00